The DIY gate system
A unique cantilever sliding gate system: any design can be mounted onto the design support profile.
Fully pre-assembled and ready to install, incl. above-ground foundation
Maximum Flexibility
Minimal preparatory work needed for foundations and conduits
Only a single small foundation required
Flexible gate height and width
Exact gate width adjustable via limit switch
Suitable for both left- and right-closing systems
Plug-and-play! Plug the cable into an outdoor socket and you're up and running!
Installed in just a few simple steps
fully automatic, safe and convenient
The design can be attached quickly and flexibly
Short delivery time
More cost-effective than classic sliding gates
The drive unit and profile sit higher up, protected from snow, water and dirt
Tor100 Home Model ranges
Maximum clear width: 4 m
Total gate length: approx. 5.30 m
The customer-supplied design is mounted onto the carrier beam (holes must be drilled on site).
Operated via Bluetooth using a free app.
Maximum clear width: 4.75 m
Total gate length: approx. 6 m
The customer-supplied design is mounted onto the horizontal support profile with slotted holes.
Operated via a 2-channel remote control
(one remote control is included)
Standard Features
- Anchor cage for concrete foundation (stainless steel)
- Carrier block with running and guide rollers (hot-dip galvanised)
- 2 pre-assembled safety contact edges on the carrier block
- 1 loose safety contact edge for the leading edge of the gate (1.7 m length, cut to size)
- 1 safety contact edge for fence system
- Obstacle detection to standard
- Integrated, robust, high-quality sliding gate drive
- Internal emergency release for manual operation
- Photocell for obstacle detection, rotatable left and right, with reflector and weather protection on the opposite side
- Mains cable 1.5 m (for on-site socket)
- Mounting hardware
- Bluetooth receiver incl. range antenna for app control
- free Bluesecure app, available for Android and iOS
- Notches in the design beam for mounting holes.
- 1 radio remote control with 2 buttons
- Horizontal support profile with slotted holes for mounting the design
Turnkey Gate System
The gate system is professionally mounted onto a precast concrete unit and commissioned at the factory. On site, everything then goes very quickly!
